Minor Repairs 371
Changing bulb for turn signal
1. Open lid.
2. Remove headlight.
Please observe the chapter “REMOVING
HEADLIGHTS” on Page 366.
Changing bulb of turn signal
3. Turn socket counter-clockwise and remove.
4. Replace the defective bulb (bayonet fitting).
5. Insert socket and turn in clockwise direction.
Make sure that the bulb is installed in the
correct position.
6. Check operation of bulb.
7. Install headlight.
Please observe the chapter “INSTALLING
HEADLIGHTS” on Page 367.
8. Close lid.
To Next Page
Loading...
Need help?
General
