Descriptions and use of inverter
Destination and appearance
Inverter (in this manual) – is an electric device, designed for transformation of
12V direct voltage into 220V alternating voltage (50 hertz frequency) at the
output.
It is used for plugging electrical appliances working from domestic circuit of
alternating current with 220V voltage and 50 hertz frequency to constant-current
source with 12V voltage.
It is possible to use any batteries and accumulators with 12V voltage as
constant-current source. As a rule, it is the majority of automobile and sea
batteries/accumulators.
Suggested list of models contains:
four models (HT-E-100, HT-E-100C, HT-E-150, HT-E-150P4),
designed for automobile application. They are supplied with a plug for
pulling it into the cigarette lighter hole. Direct plugging into
battery/accumulator is not provided.
one model (HT-E-350), which is possible to plug both in the cigarette
lighter hole and to into battery/accumulator directly. In case of plugging
devices into cigarette lighter hole, connected load is not to exceed
150W !(It is obligatory to get more specific information about
limitations of car circuit concerning plugging of equipment into
cigarette lighter hole)
three models which are to be plugged into battery ONLY DIRECTLY
.
(HT-E-600, HT-P-1200, HT-P-2500). Do not attempt to plug them into
the cigarette lighter hole, it may cause death of inverter or fusion of car
wiring.
Number in model marking denotes maximum power (permissible load) for this
model of inverter.
To Next Page
Loading...