4
Default Parameters
This table gives the default settings of all the programmable parameters. The default
settings would be restored whenever the scanner reads the "Reset" programming
label in programming mode. If you wish to change any setting, scan the appropriate
barcodes below.
Scanner Operation
Parameter Default
Same code delay 500msec
Beeping frequency Medium
Beeping duration 50msec
LED/Beep before data transmission On
Scan mode Trigger mode
Stand mode (only available for specific models) Enable
Header and trailer None
Inter message delay 0msec
Inter character delay 0msec
Interface Communication
Parameter Default
RS-232 Interface
Baud rate 9600
Parity none
Data Bits 8
Stop Bit 1
RTS/CTS off
Terminator <CR><LF>
Keyboard Wedge Interface
Terminal Type PC/AT
Keyboard US keyboard
Terminator Enter
USB Interface
Terminator type Enter
Code mode Scan code
Keyboard US keyboard
Wand Emulation
Wand emulation speed Normal
Data output Black=high
To Next Page
