Possio PM70 - Device Configuration; Power Modes; Call and GSM Settings; SMS Configuration

ENGLISH
14
15
ENGLISH
GSM SETTINGS
NO DIVERSION
Ì
60
¸
Deletes all diversion in the network.
DIVERT VOICE CALL
Ì
61
Ì
phone number
Ì
condition
¸
Diversion
0
= direct;
1
= busy;
2
= no answer;
3
= unreachable.
DIVERT DELAY
Ì
62
Ì
seconds
¸
Time before diversion, only applicable for condition
2
above.
DIVERT FAX CALL
Ì
63
Ì
fax number
¸
DIVERT DATA CALL
Ì
64
Ì
data number
¸
REQUEST DIVERTS
Ì
65
¸
Prints preset diverts.
SHOW NETWORK
Ì
70
¸
SELECT NETWORK
Ì
71
Ì
selected network
¸
Selected network
equals the digit you received from SHOW
NETWORK above. The digit
0
activates automatic roaming (the
PM70 makes an automatic choice of operator.)
EDIT WITH SMS
The settings and phone book entries might be set by sending an SMS to the PM70. This SMS must
begin with a special line and string. The format for this SMS and a template can be found through
the Possio site for information handling on the Internet, www.possio.net.
SAVE SETTINGS
Ì
20
¸
Saves the special settings-SMS after it has been received.
SAVE PHONE BOOK
Ì
21
¸
Saves the special phonebook-SMS after it has been received.
POWER MODES
Ì
57
Ì
mode
¸
Modes:
0
= deactivates travel mode and vehicle mode;
1
= activates travel mode only;
2
= activates vehicle mode only;
3
= activates both travel mode and vehicle mode
TRAVEL MODE (default) – a card or serial cable must be
attached in order to activate the PM70.
VEHICLE MODE (default) – the PM70 automatically powers up
when a charger is attached.
INCOMING CALL ID
Ì
58
Ì
0
(off) or
1
(on)
¸
Activate or deactivate the display of the incoming voice calls
number. Activated by default.
CALL DURATION
Ì
59
Ì
0
(off) or
1
(on)
¸
Activate or deactivate printing the duration of voice calls.
Activated by default.