7
ENGLISH
C H A R G I N G A N D P O W E R
CHARGING
CHARGING
Attach charger to PM70 and connect to wall socket.
Power on the PM70 by pressing
¸
for 3 seconds.
PM70 does not charge when switched off.
Always use an original Possio charger!
An empty battery must be charged for at least 3
hours before first use. A fully charged battery allows
for 15–21 hours usage (depending on whether a
Connectivity Card is attached or not).
Power Modes: when Travel Mode is activated a
card or serial cable must be attached in order to
start charging the machine. This can be bypassed
by a RESET (see below). When Vehicle Mode is
activated the PM70 automatically powers up to start
charging when a charger is attached. Read more
about Power Modes under SETTINGS.
POWER
ON
Press
¸
for 3 seconds.
Power Modes: when Travel Mode is activated a
card or serial cable must be attached in order to
start the machine. This can be bypassed by a RESET
(see below). When Vehicle Mode is activated the
PM70 automatically powers up when a charger is
attached. Read more about Power Modes under
SETTINGS.
OFF
Press
˜
for 3 seconds.
To save battery PM70 is automatically switched off
after a defined time, POWER-DOWN. The time
between last action and power-down might be
set. See more under SETTINGS. If connected to a
charger the PM70 does not enter power-down.
RESET
Press
ò ÷ î
simultaneously to reset the
machine. The settings will be saved and the PM70
will turn on after the reset. Resetting cancels all PM70
activities.
To Next Page
Loading...