Need help?Do you have a question about the Pottinger TOP 762 C and is the answer not in the manual?
Explanation of DANGER, WARNING, CAUTION, and NOTE symbols for safe operation.
Operator awareness of functions, implement safety, and hazard warnings.
Pre-operation checks for safety equipment, lubrication, tyres, and connections.
Required tractor power and hitch category for operating the machine.
Importance of front axle load for steering and braking capacity.
Details on single-acting and dual-action hydraulic connections needed.
Steps for hitching the machine to the tractor, including headstock and pins.
Instructions for fitting the PTO shaft, including safety and length adaptation.
Safety measures for parking the machine, including anti-theft device.
Steps to safely convert the machine from working to transport mode.
Procedure for changing from headland to transport position.
Regulations and safety checks for driving the machine on public roads.
Steps to reduce transport height, especially with specific tyre sizes.
DANGER and WARNINGs for operating the machine, including rotating parts and noise.
Key steps before starting operation, including PTO engagement and speed.
Adjusting tine height, checking air pressure, hoses, and screws.
DANGER and WARNINGs related to rotating rotors, folding arms, and thrown material.
Steps to safely convert the machine from transport to working mode.
Requirements and procedures for setting rotor chassis and cross slope.
Procedure for setting rake height for each rotor unit individually.
Procedure for raising a single rotor or continuing with two rotors.
Procedure for swivelling the machine from working to headland position.
Steps for adjusting the working width on the machine arm.
DANGER warning about tractor/trailer tipping on inclines, especially when cornering.
DANGER warnings for moving/rotating parts and working under the machine.
Hydraulic schematic for raising/lowering rotors on standard models.
Hydraulic schematic for raising/lowering rotors on the TOP 612 C model.
Hydraulic schematic for working width adjustment on specific models.
Hydraulic schematic for single rotor operation on specific models.
Hydraulic schematic for models equipped with a flow divider.
Hydraulic schematic for single rotor operation with flow divider.
Crucial safety instructions for PTO operation, cardan shafts, and overload protection.
Instructions for adapting, cutting, and maintaining cardan shafts.
Calculation method for total weight, axle loads, and required minimum ballasting.
General| Brand | Pottinger |
|---|---|
| Model | TOP 762 C |
| Category | Farm Equipment |
| Language | English |
To Next Page