EasyManua.ls Logo

Poulan Pro 428695 - User Manual

Poulan Pro 428695
40 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OWNER'S MANUAL
MODEL NUMBER:
PR827ES
SNOW THROWER
Always Wear Eye Protection During Operation
IMPORTANT MANUAL Do Not Throw Away
WARNING:
Read the Owner's Manual and
fol low all Warnings and Safety
In struc tions. Fail ure to do so
can result in serious injury.
428695 07.31.09 TH
Printed in the U.S.A.

Table of Contents

Questions and Answers

  • J
    Jose LopezAug 11, 2025
    How to fix Poulan Pro Snow Blower that does not start?
    • H
      hernandezwilliamAug 11, 2025
      If your Poulan Pro Snow Blower doesn't start, several factors could be the cause. First, ensure the fuel shut-off valve is in the OPEN position and the safety ignition key is inserted. Check that you have enough fresh, clean gasoline in the fuel tank. Make sure the throttle is in the FAST position (or the ON/OFF switch is ON) and the choke is in the FULL position. If it still doesn't start, prime the engine as instructed in the manual. If the engine is flooded, wait a few minutes before restarting and avoid priming. Check that the spark plug wire is connected, and if the spark plug is bad, replace it. Finally, stale or water-contaminated fuel can also prevent starting; in this case, empty the fuel tank and carburetor, then refill with fresh, clean gasoline.
  • L
    Lisa SerranoAug 17, 2025
    Why Poulan Pro Snow Blower losing power?
    • W
      William SandovalAug 17, 2025
      If your Poulan Pro Snow Blower is losing power, start by checking if the spark plug wire is loose and reconnect it if necessary. You might be trying to throw too much snow at once; reduce your speed and the width of your path. Also, make sure the fuel tank cap isn't covered with ice or snow, and if it is, clear it off. A dirty or clogged muffler can also cause power loss, so clean or replace it.
  • S
    Sean JonesAug 23, 2025
    What to do if Poulan Pro Snow Blower engine idles or runs roughly?
    • M
      Maria PerkinsAug 23, 2025
      If the engine of your Poulan Pro Snow Blower idles or runs roughly, try these steps: First, ensure the choke is in the OFF position. Check for any blockages in the fuel line and clean it if necessary. If the fuel is stale or contaminated with water, empty the fuel tank and carburetor, then refill with fresh, clean gasoline.
  • J
    Jeffery WhiteAug 29, 2025
    How to fix loss of snow discharge on Poulan Pro Snow Blower?
    • J
      James WilsonAug 29, 2025
      If your Poulan Pro Snow Blower experiences a loss or slowing of snow discharge, first check if the auger belt is off the pulley and reinstall it if needed. Also, inspect the auger belt for wear and replace it if necessary. A clogged discharge chute can restrict snow flow, so clear the snow chute. Finally, remove any debris or foreign objects from the augers or impeller that may be causing a jam.
  • S
    scottzacharySep 5, 2025
    What to do if Poulan Pro Snow Blower has loss of traction drive?
    • N
      Nicole NavarroSep 5, 2025
      If your Poulan Pro Snow Blower is losing traction or drive speed, check if the drive belt is worn and replace it if needed. Also, verify that the drive belt is properly on the pulley and reinstall it if it has come off.

Poulan Pro 428695 Specifications

General IconGeneral
Engine208cc
Auger TypeSteel
Engine Type4-Cycle
Engine Displacement208 cc
Start TypeRecoil

Related product manuals