5
CHARGER MOUNTING
1. This charger can be installed hanging on a
wall using two screws (not supplied).
2. Locate the wall mounting placement on
bottom of charger.
3. If fastening to wood studs use 2 wood
screws.
4. Drill two holes 2 3/8” (6 cm) on center
ensuring they are level.
5. If fastening to drywall use wall anchors and
screws to secure the charger to the wall.
CHARGER MAINTENANCE
• Keep the charger clean and clear of
debris. Do not allow foreign material into
the recessed cavity or on the contacts.
Wipe with a dry cloth. Do not use solvents,
water, or place in wet conditions.
• Unplug the charger when there is no
battery pack in it.
• Fully charge the batteries before placing
them in storage.
Store the charger at normal room
temperature. Do not store it in excessive heat.
Do not use the charger in direct sunlight.
Recharge at room temperature between 32
and 104°F (0 and 40°C).
If the battery pack is hot, allow it to cool down
before charging.
WARNING:
In order to avoid
personal injury and the risk of re and electric
shock, remove the battery before adjusting,
inspecting, or cleaning the battery.
IMPORTANT SAFETY INSTRUCTIONS –
SAVE THESE INSTRUCTIONS
DANGER – TO REDUCE THE RISK OF
FIRE OR ELECTRIC SHOCK, CAREFULLY
FOLLOW THESE INSTRUCTIONS
CAUTION
:
• If the battery and the charger won’t be
used for a long time, please remove the
battery from the charger and pull out the
AC power plug.
• This power unit is intended to be correctly
orientated in a vertical or oor mount
position
To Next Page
Loading...