Poulan Pro PR700AWD User Manual

Poulan Pro PR700AWD

36 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

SELF-PROPELLED ROTARY

LAWN MOWER

115 58 78-27 Rev. 4

04.23.15 BY Printed in U.S.A.

Table of Contents

Questions and Answers:

E
Emily ChavezAug 12, 2025
How to fix a Poulan Pro Lawn Mower that does not start?
- K
  karenschwartzAug 13, 2025
  If your Poulan Pro Lawn Mower won't start, there are several potential causes: * A dirty air filter may be the culprit; clean or replace it. * The fuel tank may be empty; refill it. * Stale or contaminated fuel can also prevent starting; drain the tank and refill with fresh, clean gasoline. * Ensure the spark plug wire is connected, the spark plug is in good condition, the blade and blade adapter are properly tightened, and the control bar is correctly positioned and functional. * Also, check the fuel valve lever, battery, battery connector, and fuse if your mower is equipped with these features.
L
laurenpattersonAug 16, 2025
Why Poulan Pro PR700AWD losing power?
- N
  Nicole GordonAug 16, 2025
  If your Poulan Pro Lawn Mower is losing power, it might be due to several reasons. One common cause is the mower housing or blade dragging in heavy grass; raise the cutting height to resolve this. Also, avoid cutting too much grass at once, and ensure the air filter is clean. A buildup of grass and debris under the mower can also cause power loss, so clean the underside of the mower housing. Finally, check the engine oil level and reduce your walking speed while mowing.
C
Christopher AndersonAug 20, 2025
Why is the starter rope hard to pull on my Poulan Pro Lawn Mower?
- M
  Michelle TaylorAug 20, 2025
  If your Poulan Pro Lawn Mower's starter rope is hard to pull, it could be due to several reasons. Ensure the engine flywheel brake is not engaged by depressing the control bar before pulling the rope. Other potential causes include a bent engine crankshaft, a broken blade adapter, or the blade dragging in the grass. If the crankshaft is bent, contact a qualified service center.
E
Edward HendersonAug 25, 2025
What to do if grass catcher not filling on Poulan Pro PR700AWD Lawn Mower?
- G
  gespinozaAug 25, 2025
  If the grass catcher on your Poulan Pro Lawn Mower isn't filling properly, first check if the cutting height is too low and raise it if necessary. Also, inspect the blade for wear that may have reduced its lift and replace the blade if needed. Finally, ensure the grass catcher is venting air properly by cleaning it.
J
Joseph ClarkAug 27, 2025
Why Poulan Pro PR700AWD Lawn Mower loss of drive or slowing of drive speed?
- E
  Emily BrownAug 27, 2025
  If your Poulan Pro Lawn Mower is losing drive or the drive speed is slowing, inspect the drive belt for wear and replace if necessary. Also, check if the belt is off the pulley and reinstall it if needed. If the drive cable is worn or broken, replace it. Finally, check for a loose drive control system and adjust the drive control.
S
Steven ForbesAug 31, 2025
What to do if Poulan Pro Lawn Mower has poor cut – uneven?
- D
  Dustin MoralesAug 31, 2025
  If your Poulan Pro Lawn Mower provides a poor or uneven cut, inspect the blade for wear, bends, or looseness; replace or tighten as necessary. Ensure all wheel heights are set evenly. Also, check for any buildup of grass, leaves, or trash under the mower and clean the mower housing if needed.
V
vazquezmitchellSep 4, 2025
Why is my Poulan Pro Lawn Mower hard to push?
- Y
  youngjohnSep 4, 2025
  If your Poulan Pro Lawn Mower is hard to push, it could be because the grass is too high, or the wheel height is too low; try raising the cutting height. Additionally, ensure the rear of the mower housing isn't dragging in the grass by raising it one setting higher. A full grass catcher can also make the mower harder to push, so empty it regularly. Lastly, adjust the handle height to a comfortable position.
M
markestradaSep 8, 2025
Why is my Poulan Pro PR700AWD Lawn Mower vibrating excessively?
- C
  colecarlSep 8, 2025
  If your Poulan Pro Lawn Mower is experiencing excessive vibration, inspect the blade for wear, bends, or looseness; replace or tighten as necessary. If the engine crankshaft is bent, contact a qualified service center.

Poulan Pro PR700AWD Specifications

General

Engine Type	4-Cycle
Engine	Briggs & Stratton
Cutting Width	21 inches
Cutting Height	1.25 - 3.75 inches
Cutting Height Adjustments	6 positions
Mulch/Bag/Side Discharge	3-in-1
Rear Bag Capacity	1.9 bushels
Front Wheel Size	8 inches
Rear Wheel Size	11 inches
Oil Capacity	20 oz
Drive Type	All-wheel drive (AWD)
Fuel Capacity	1.6 qt
Warranty	2 years limited

Summary

Safety Rules

Children Safety

Safety precautions for children operating or being near the lawn mower.

General Operation Safety

Instructions for safe operation of the lawn mower to prevent injury.

Slope Operation Safety

Guidelines for safely mowing on slopes to prevent slips and falls.

Gasoline Handling Safety

Precautions for handling gasoline to prevent injury and property damage.

General Service Safety

Safety rules for general maintenance and service of the lawn mower.

Operation

Engine Speed Control

How to control engine speed using the throttle lever or fixed speed settings.

Cutting Height Adjustment

Procedures for adjusting the cutting height of the lawn mower.

Mower Conversion Procedures

Instructions for converting the mower between mulching, bagging, or discharging modes.

Operator Presence Control Bar

Explanation of the operator presence control bar and its safety function.

Drive Control Systems

How to use different drive control systems for self-propelling the mower.

Pre-Start Engine Checks

Steps and precautions before starting the engine, including fluid checks.

Engine Starting Procedure

Procedures for starting the engine using recoil or electric start methods.

Engine Stopping Procedure

How to safely stop the lawn mower engine.

Mowing Techniques

Maintenance

Maintenance Schedule

Blade Care and Replacement

Engine Oil and Filter Maintenance

Spark Plug Replacement

Service and Adjustments

Handle Height Adjustment

Drive Belt Replacement Procedures

Troubleshooting

Engine Starting Problems

Common causes and corrections for the engine failing to start.

Power Loss and Uneven Cutting

Reasons for loss of power, uneven cut, vibration, and hard starting.

Vibration and Starter Rope Issues

Drive System Issues

Related product manuals

Preview: Poulan Pro PR725Y22RHP

Poulan Pro PR725Y22RHP

Poulan Pro PRLM21i

Poulan Pro PR1842STD

Poulan Pro PR1842STC

Preview: Poulan Pro PR55R21AB

Poulan Pro PR55R21AB

Preview: Poulan Pro PRGT25H48A

Poulan Pro PRGT25H48A

Preview: Poulan Pro PR173Y22RP

Poulan Pro PR173Y22RP

Preview: Poulan Pro PR600Y21RP

Poulan Pro PR600Y21RP

Preview: Poulan Pro PR600N22SH

Poulan Pro PR600N22SH

Poulan Pro PR16H42STA

Poulan Pro PR17H42STF

Poulan Pro PR20H42STC