Searching
• The trolley will start searching for GPS signal. This can take
up to 5 minutes depending on location and signal strength.
For best results, operate away from buildings in an open sky
position.
• If no signal is acquired after 5 minutes, a Low Signal message
will be displayed. Move to a better GPS signal strength area and
the trolley will continue searching.
You can operate the motor functions while the GPS device identies
your location. Once the device has a GPS lock a list of up to 10 local
courses will be displayed. Navigate the list by using the up & down
arrows on the right side of the display.
Select a Course by:
1. Press the desired course from the list. Your selection will turn
green.
2. Conrm by pressing the blue ‘LOAD COURSE’ button at the
bottom of the display.
3. The trolley will take a few seconds to load the data.
Demo Mode:
Will allow the user to explore the display screens and trolley
function without requiring a GPS signal lock.
• Select the ‘DEMO’ button from the Home Menu.
• The display mimics the trolley searching for a GPS lock and then
will present a list of courses for the user to choose from.
• Select the desired course and conrm by pressing the blue
‘LOAD COURSE’ button.
• Once the data has loaded, swipe left and right between the GPS
distance measurement modes, view the scorecard function and
browse the Settings Menu. See Section 11 and 13 for further
details.
Note: the information shown in demo mode is only to
demonstrate the product and may not be accurate course
information.
• To exit Demo Mode, enter the Settings Menu and navigate to
page 3. Press the Red ‘EXIT DEMO’ button.
Note: no motor functions are available in Demo Mode.
Navigation ArrowsPress to Load Course
Course Highlighted
End Demo Mode
9
Trolley Controls
Power IndicatorSpeed Setting
Speed Setting: Rotate the control dial to adjust the speed of the
trolley from 0 - 9. Press control dial to start/pause and resume your
selected speed.
Note: the motor has a 15 minute timeout function and will pause the motor after
running continuously for this duration. Press the control dial to resume.
Power Indicator: Displays whether power is being applied to the
drive system. (Green - ON) (Red - OFF)
Automatic Distance Function (ADF): The ADF function is a
convenient way of sending your trolley a set distance (5 to 50
yards/metres); for example, when you are approaching a green you
can send the trolley towards the next tee if the route allows.