Maintenance
Wipe your PowaKaddy RoboKaddy after each outing to ensure it runs
smoothly and keeps it’s good looks.
To keep the cart clean, use a mild detergent and warm water. Do not
use any high pressure jet washers since the contents of the handset,
the handle and the base controller will be damaged by water ingress.
Remove the main wheels every few months and remove any debris that
might cause the wheels to drag. Clean the spindle and lightly grease
before replacing the wheels.
The screws in the battery tray are sealed in the factory to prevent water
getting into the controller underneath. If you loosen these screws for
any reason, you MUST re-seal them with silicone sealant.
A four hour round of golf played once a week for 12 months is
equivalent to, say, four years use out of a lawnmower. So once a year,
at least, thoroughly inspect your cart, and if you notice any symptoms
of wear, consult your local PowaKaddy service agent.
It is advisable to have your charger checked periodically, particularly
when buying a new battery. This will ensure that your charger is still
charging correctly and ensure maximum life of your new battery.
Always put your machine together before connecting the battery.
If you prefer not to leave your battery on charge, as you know that you
will not be playing for at least a month, you can store the battery. Fully
charge the battery, remove from the charger and store in a place where
the ambient temperature is above 10 degrees Celsius (+10º C) and less
than 30 degrees Celsius (+30ºC). Recharge every 3 months for 24
hours and before your next round.
RoboKaddy
13
To Next Page
Loading...
Need help?
General
