Power Craft PPCS-38cc User Manual (English)

Questions and Answers:

E
eric25Aug 1, 2025
What to do if my Power Craft PPCS-38cc Chainsaw won't start?
- J
  James CherryAug 1, 2025
  If your Power Craft Chainsaw won't start, there are several potential causes: * Incorrect starting procedures: Follow the instructions in the User Manual. * Fouled spark plug: Clean, gap, or replace the plug. * Fuel filter plugged: Replace the fuel filter. * Incorrect carburetor mixture adjustment setting: Have the carburetor adjusted by an Authorized Service Center. * Move to RUN position. * Replace spark arrester screen. * Remove, clean and reinstall filter. * Use properly mixed fuel (40:1 mixture).
W
waltercoleAug 7, 2025
Why does my Power Craft PPCS-38cc start but have low power?
- C
  Catherine FloydAug 7, 2025
  If your Power Craft Chainsaw starts but has low power, possible causes include: * Incorrect lever position on choke. * Dirty spark arrester screen. * Dirty air filter. * Incorrect carburetor mixture adjustment setting.
C
Corey ChangAug 13, 2025
Why does my Power Craft PPCS-38cc Chainsaw smoke excessively?
- H
  Holly TorresAug 13, 2025
  If your Power Craft Chainsaw smokes excessively, it could be due to: * Incorrect carburetor mixture adjustment setting. * Incorrect fuel mixture.
C
Catherine PerkinsAug 26, 2025
How to fix a Power Craft Chainsaw that runs erratically?
- T
  timothyfreemanAug 26, 2025
  If your Power Craft Chainsaw runs erratically, it could be due to an incorrectly gapped spark plug.
M
Matthew JonesSep 10, 2025
What to do if my Power Craft Chainsaw engine hesitates?