6
10. DAMAGED OR DROPPED
Always inspect your power tool before use. Check guards and other
parts are correctly attached. Do not use this power tool if it has been
damaged, dropped, left outdoors or dropped in water. Return it to an
authorised service dealer for examination and repair.
11. STORE IN A SAFE PLACE
When not in use store your tool and all its accessories and instruction
manual in a safe and dry place.
OPERATION
• Fitting and removing bits
Select the desired short chrome vanadium
bit, insert the bit into the bit holder and
push the bit holder into the chuck as far as
possible. Always use a bit holder when
using short bits. (See diagram 1)
• Forward / Reverse Switch
This allows direction to be changed for
driving and removing screws and sockets.
Push the top of the rocker switch for driving
forward and push the bottom of the rocker
switch for removing screws or reverse
operation (See diagram 2)
To Next Page
Loading...
Need help?
General
