To Next Page
J
Joshua SmithNov 2, 2025
What to do if Power Fist Water Pump engine runs but no water is delivered?
- GGeorge SkinnerNov 3, 2025
If your Power Fist Water Pump's engine runs but isn't delivering water, consider these possibilities. If it's a new installation, improper priming or air leaks could be the issue; reprime the pump according to the instructions and check all connections on the suction line, air volume control, and ejector. For installations already in use, air leaks or a water level below the pump's suction could be the cause; inspect connections on the suction line, volume control, ejector, and shaft seal, and lower the suction line into the water to reprime. If the ejector or impeller is plugged, clean it. Also, check if the check valve or foot valve is stuck closed and replace if necessary. Finally, ensure the strainer isn't buried in sand or mud; if so, raise it above the well bottom. If the water level...
General
