Power-Pole C-MONSTER User Manual

C-MONSTER TOP SIDE PROGRAMMING
INSTRUCTIONS
STEP 1: Setting HPU (Hydraulic Pump Unit) as a single, or port, or starboard units (duals)
1. Press and hold the PROGRAM button for 6 seconds until LED flashes red and two chimes are heard followed by
a single beep. (FIG. 1)

• Set as a single HPU:
Press and hold both Up and Down buttons simultaneously.
• Set as starboard side HPU:
Press and release the Up button.
• Set as port side HPU:
Press and release the Down button.
Once you have made the desired setting change,
press and release the PROGRAM button to save your setting
and exit. You will hear a series of beeps and the LED
light will return to flashing green.
IMPORTANT: When using only one anchor, do not
program as a port or starboard.
STEP 2: Pair additional
C-Monster controllers
(up to 10 controllers can be paired to a single HPU)
1. Press and hold the PROGRAM button on the HPU
for 3 seconds. A solid green light and a single beep
will confirm that the unit is in pairing mode.
2. Press the UP button on the C-Monster controller for one second and release. A beep will sound to confirm that
a new C-Monster controller has been paired.
NOTE: A single C-Monster Controller can be programmed to multiple anchors.
Programming
Button
Up Button
Down Button
Figure 1
Need help? Contact our Technical Support Team at 1 + 813.689.9932 Option 2
©2017 all rights reserved. Power-Pole Shallow Water Anchor U.S. Patent No. 6,041,730

Power-Pole C-MONSTER Specifications

General

Brand	Power-Pole
Model	C-MONSTER
Category	Boating Equipment
Language	English