Figure 18
NOTE: The Power-Pole anchor comes paired to the
included Dash Switch and Key Fob remotes. When
installing dual anchors, you can program a single
Dash Switch and/or Key Fob remote to control both
units as follows:
1. Determine which unit is paired with the controller by
pressing the UP or DOWN button.
2. Locate the PROGRAM button on the top of the other
HPU. Depress and hold it for 3 seconds until the LED
turns solid green in color and a single beep is heard.
3. Press the UP or DOWN button on the controller until the
unit moves or responds (
FIG. 18)
1. Locate a suitable area with a flat surface to mount the
Dash Switch.
2. Mark and drill a pilot hole with 7/64” drill bit to fasten switch
using the (2) flat head screws
G
supplied (do not over
tighten). Or you may choose to use the supplied adhesive
strip
N
instead (not shown).
Program Button
LED Light
STEP8
STEP9
Pairing Dual Units To A Single Wireless Controller
Installing The Dash Switch
G
G
www.power-pole.com
To Next Page
Loading...
Need help?
General
