Power Probe Pro-Solder 50 - Charging Instructions

Charging Instructions
This soldering is rechargeable. Using the supplied cable, insert the Micro USB con-
nector into the end of the soldering iron, and the USB connector to a wall charger /
computer port.
A full charge will take approximately 3.5 hours. Once charged, the indicator light will
turn green.
Cap
Chisel Soldering Tip
Knurled Nut
Locking Nut
LED Light
Power Button
ON/OFF Switch
Notch
Micro-USB Port
10 gram lead free solder
Point Soldering Tip
Brass tip cleaner
Safety Stand
USB Connector
Micro USB Connector
Heat Shrink Tip
EN
02