Power Sentry PS600 MVOLT - Page 7

Installation Instructions for Power Sentry Emergency Battery Packs –QD MVOLT Series
Page 7
CONNECT RED WIRE TO POINT “A”
FOR ONE LAMP OR TO POINT “B”
FOR TWO LAMP EMERGENCY
OPERATION
CAUTION
REFER TO LAMP SELECTOR TABLE
BEFORE CHANGING POSITIONS
LAMP SELECTOR (PS 1400 ONLY)
BALLAST POWER CONNECTION
120 TO 277 VAC SWITCHED OR
UNSWITCHED LINE –
NOTE; VERIFY VOLTAGE RATING
ON LAMP BALLAST
CONNECT BLACK AND ORANGE
LEADS TOGETHER IF ORANGE
WIRE IS PRESENT
120 TO 277 VAC
UNSWITCHED LINE
TEST SWITCH/PILOT LIGHT
SINGLE
EMERG. LAMP
CONNECTION
“A”
TWO EMERG. LAMP CONNECTION
“B”
MVOLT
BATTERY PACK
THREE LAMP RAPID START BALLAST
Figure C
FOUR LAMP RAPID START BALLAST
SINGLE
EMERG. LAMP
CONNECTION
“A”
“B”
TWO EMERG. LAMP CONNECTION
CONNECT RED WIRE TO POINT “A”
FOR ONE LAMP OR TO POINT “B”
FOR TWO LAMP EMERGENCY
OPERATION
BALLAST POWER CONNECTION
120 TO 277 VAC SWITCHED OR
UNSWITCHED LINE –
NOTE; VERIFY VOLTAGE RATING
ON LAMP BALLAST
CONNECT BLACK AND ORANGE
LEADS TOGETHER IF ORANGE
WIRE IS PRESENT
120 TO 277 VAC
UNSWITCHED LINE
LAMP SELECTOR (PS 1400 ONLY)
CAUTION
REFER TO LAMP SELECTOR TABLE
BEFORE CHANGING POSITIONS
MVOLT
BATTERY PACK
TEST SWITCH/PILOT LIGHT
Figure D