Power smart DB1051 - User Manual

Questions and Answers

D
Dustin KellyAug 12, 2025
Why won't my Power smart Pressure Washer engine start?
- J
  Jasmine JonesAug 12, 2025
  Your Power smart Pressure Washer engine might not start due to several reasons: * There's no fuel: add fresh fuel. * Pressure build-up: squeeze the gun trigger to relieve pressure. * Choke lever is in the "No Choke" position: move it to the "Choke" position. * Spark plug wire is not attached: attach it. * Engine switch is in the OFF position: place it in the ON position. * Choke lever is in the "Choke" position on a hot engine: move it to the "No Choke" position.
V
vanessavegaAug 18, 2025
What to do if my Power smart Pressure Washer has no or low pressure on initial use?
- T
  thompsonwendyAug 18, 2025
  If your Power smart Pressure Washer has no or low pressure during initial use, consider these potential causes: * The spray wand is not in high pressure. * There is low water supply: ensure a supply of at least 5 gpm @ 20 PSI. * There is a leak at the high-pressure hose fitting: repair the leak, applying sealant tape if needed. * The nozzle is obstructed. * The water filter screen is clogged: remove and clean the filter. * There is air in the hose: turn off the engine and water source, disconnect the water source, turn the water on to remove air, then reconnect and squeeze the trigger. * The choke is in the “Choke” position: move it to the “No Choke” Position. * The high-pressure hose is too long: use a hose under 100 feet (30 m).
J
John SmithAug 27, 2025
What to do if my Power smart Pressure Washer won't draw chemicals?
- C
  Christina RoseAug 27, 2025
  If your Power smart Pressure Washer isn't drawing chemicals, check these potential issues: * The spray wand isn't in low pressure. * The chemical filter is clogged: clean the filter. * The chemical screen isn't in the cleaning solution: fully submerge the detergent siphon hose into the solution. * The chemical is too thick: dilute it to the consistency of water. * The pressure hose is too long: lengthen the water supply hose instead.
M
Marcus HerreraSep 2, 2025
What to do if water is leaking at the gun or spray wand connection of my Power smart Pressure Washer?
- T
  Taylor GriffinSep 3, 2025
  If you notice water leaking at the gun or spray wand connection of your Power smart Pressure Washer, it could be due to: * A worn or torn o-ring: check and replace it. * A loose hose connection: tighten the connection.

Power smart DB1051 Specifications

General

Max Pressure	1500 PSI
Weight	5.7kg
Hose Length	5m
Power Source	Electric
Flow Rate	6.5 L/min
Water Flow	6.5 L/min

Power smart DB1051 - User Manual

Table of Contents

Questions and Answers

Power smart DB1051 Specifications