20
GENERATING SET MAINTENANCE
WARNING: Never clean the generator when it is running! Never use water to clean the
generating set. Water can enter the generating set through the cooling slots and damage the
generating set windings.
WARNING: Do not modify the generator in any way. Do not tamper with governed speed.
Generator supplies correct rated frequency and voltage when running at factory set. Tampering
with the factory set governor will void your warranty.
Make certain that the generator is kept clean and stored properly.
Use a damp cloth to clean exterior surfaces of the generating set. Use a soft brush to clean the dirt and
oil.
Use an air compressor (25 PSI) to clear dirt and debris from the generating set.
Inspect all air vents and cooling slots to ensure that they are clean and unobstructed.
ENGINE MAINTENANCE
Changing the oil
WARNING: Change the oil when the engine is warm form operation. The oil can reach up to
140
℃
under that condition. Careful operation should be taken to prevent burns.
1. Place the machine on a level surface which is 300mm higher than the ground.
2. Remove the air filter maintenance cover.
3. Remove the oil drain plug.
4. Place the oil container box under the oil drain hole of the generator and remove the drain bolt to drain
out all the used oil.
To Next Page
Loading...
Need help?
General
