Power Tech-On PS1001 - User Manual

Questions and Answers

T
Tonya AguilarAug 7, 2025
What to do if Power Tech-On Inverter has no output voltage and the buzzer sounds continuously?
- M
  maciaskarenAug 7, 2025
  If your Power Tech-On Inverter isn't providing any output voltage and the buzzer is continuously sounding, it could be due to several reasons: the input DC voltage might be too low, in which case you should recharge or replace the battery; the input DC voltage might be too high, avoid using it when the battery is charging and check the rated voltage of the battery; there might be an overload, so try reducing the load power; or the inverter might be overheating, cut off the load and allow it to cool naturally for 10 to 30 minutes before restarting, also reduce the total load power and improve ventilation, and reduce the ambient temperature.
A
Amanda PenaAug 17, 2025
Why my Power Tech-On Inverter cannot drive the load?
- M
  Michael JonesAug 17, 2025
  Your Power Tech-On Inverter might fail to drive the load because the load power is too large, or the actual power of the appliance exceeds nominal power. Try reducing the load power. Alternatively, first open the appliance, then open the inverter; the inverter's internal soft-start circuit will buffer the start of the appliances.
E
elizabethsmithAug 27, 2025
What to do if Power Tech-On PS1001 Inverter causes static on TV or audio?
- D
  Denise RichardsonAug 27, 2025
  If you're experiencing static on the screen, static noise, or no audio when using your Power Tech-On Inverter with a TV or audio device, it may be due to disturbance. Try separating the inverter and antenna, or use a screened antenna.