Power Tech-On PS1005 - User Manual

Questions and Answers

L
Lindsey OrrAug 9, 2025
What to do if Power Tech-On PS1005 Inverter has no output voltage and the buzzer sounds continuously?
- S
  Samantha PerezAug 9, 2025
  If your Power Tech-On Inverter isn't providing any output voltage and the buzzer is continuously sounding, it could be due to several reasons: the input DC voltage might be too low, in which case you should recharge or replace the battery; the input DC voltage might be too high, avoid using it when the battery is charging and check the rated voltage of the battery; there might be an overload, so try reducing the load power; or the inverter might be overheating, cut off the load and allow it to cool naturally for 10 to 30 minutes before restarting, also reduce the total load power and improve ventilation, and reduce the ambient temperature.
A
Amy ColeAug 19, 2025
Why my Power Tech-On PS1005 Inverter cannot drive the load?
- M
  Martin NguyenAug 19, 2025
  Your Power Tech-On Inverter might fail to drive the load because the load power is too large, or the actual power of the appliance exceeds nominal power. Try reducing the load power. Alternatively, first open the appliance, then open the inverter; the inverter's internal soft-start circuit will buffer the start of the appliances.
D
Debra TaylorAug 29, 2025
What to do if Power Tech-On PS1005 causes static on TV or audio?
- J
  Joseph ThomasAug 29, 2025
  If you're experiencing static on the screen, static noise, or no audio when using your Power Tech-On Inverter with a TV or audio device, it may be due to disturbance. Try separating the inverter and antenna, or use a screened antenna.

Summary

Important Safety Instructions

General Safety Guidelines

Essential safety instructions for operating the inverter, including protection from water and proper wiring.

Warning: Explosion Hazard

Battery Area Hazards

Warnings about explosive gases from lead-acid batteries and sparks from equipment near flammable materials.

Precautions When Working With Batteries

Safe Battery Handling

Precautions for working near batteries, including ventilation, avoiding sparks, metal objects, and proper acid handling.

Warning: Fire & Explosion Hazard

Inverter Installation Stability

Using the Inverter

How to Use the USB Power Supply

Functions

Input Voltage Protection

Load and Thermal Protection

Troubleshooting

Common Faults and Solutions

Table addressing common issues like no output voltage, overload, and over-temperature, with corresponding solutions.

Power Tech-On PS1005 Specifications

General

Input Voltage	12V DC
Output Voltage	110V AC
Continuous Power	1000W
Surge Power	2000W
Output Power	1000W
Peak Power	2000W
Frequency	60Hz
Efficiency	90%
Protection	Overload, Over Temperature, Short Circuit
Cooling	Fan