14
Assembly
• Bend the plastic tip at the end of the microphone cord so
that it forms a "T".
• Insert the "T" end of the microphone cord into the hole in
the handlebar. Pull gently on the microphone cord to
make sure it is secure in the handlebar.
• Hang the microphone on the handlebar.
• Fit a hand grip onto each end of the handlebar. If it is
difficult to slide the hand grips onto the handlebar,
moisten the hand grips with warm water first.
Handlebar
Hole
Hand Grip
Microphone
"T" End
• Apply labels as shown. For best results, make sure your
hands and the areas to which the labels will be applied
are clean and dry.
Dash and Rear View
18
19
9
8
5
To Next Page
Loading...
