3 Declaration of conformity
DECLARATION OF CONFORMITY
Saxonar GmbH hereby declares that the power2max power meter complies with the essential
requirements and further relevant provisions of the 1999/5/EC Directive. The complete declaration
of conformity is available at https://www.power2max.de
Statement of Compliance for FCC and lndustry Canada
This equipment has been tested and found to comply with the Iimits for a Class B digital device,
pursuant to Part 15C of the FCC Rules and Radio Standards Specification RSS-247, Issue 1. These
Iimits are designed to provide reasonable protection against harmful interference in a residential
Installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
Installation.
Operation is subject to the following two conditions: This device may not cause harmful interference,
and this device must accept any interference received, including interference that may cause
undesired operation. This product meets the applicable lndustry Canada technical specifications. The
term „IC:“ before the radio certification number only signifies that lndustry Canada technical
specifications were met.
WARNING:
Any changes or modifications not expressively approved by Saxonar GmbH could void the user‘s
authority to operate this equipment.
Statement of RoHS Compliance
Saxonar GmbH certifies that this product and its packaging are in compliance with European Union
Directive 2002/195/EC on the Restriction of the Use of Certain Hazardous Substances in Electrical
and Electronics Equipment, commonly known as RoHS.
To Next Page
Loading...
Need help?
Battery
Transmission Standards