20
6. TERMINATING STIMULATION
It’s important to know the quick ways to end your stimulation
when something unexpected happens (e.g. one of the pads gets
detached; the intensity increases unexpectedly; the stimulation
area gets wet, etc.).
There are 3 main ways to immediately terminate stimulation:
• The recommended/most commonly used option: Tap Pause
or Stop on the Stimulation screen
• Alternatively: Press the Multifunction Button on your
PowerDot (or on any PowerDot when in Duo mode)
• Only in emergencies: Unplug the lead cable from PowerDot.
7. CARRYING & STORING POWERDOT
PowerDot carry case is specifically designed for carrying and
storing your PowerDot device, cables and electrode pads.
To keep electrode pads clean and make them last longer, always
re-attach them to the safety film in between uses, then store them
in your carrying case pocket. You can use both sides of asingle
safety film to attach one set of PowerDot electrode pads (one side
for the rectangular pad and the other for the two round pads).
8. DEACTIVATING POWERDOT
PowerDot can be deactivated and unpaired from a mobile phone
either from within the Mobile Application or by manually turning
off the device.
For manual deactivation: When PowerDot is ON and not in
stimulation, press and hold down the Multifunction Button for
5 seconds until you see the power indicator blinking several
times. When you turn on your PowerDot again, it will already
be fully deactivated.
To Next Page
Loading...