■ 4
│
GB
│
IE
│
NI
PUTK 50 A1
Use
♦ Undo the elastic fastening bungee and unfold the product until it audibly
clicks into place (see fig. 1).
♦ Press the knob on the handle and pull the telescopic bar out until it clicks
into place (see fig. 2).
WARNING! RISK OF INJURY!
► Do not stretch the fastening bungee more than the maximum usable
length of 130cm. Keep your eyes, face and unprotected body parts
out of range of a possible springback.
NOTE
► The fastening bungee must be under tension to ensure that the load is
held in place. Observe the size of the load.
► Never apply a load of more than 50 kg.
♦ Place a load onto the load area. Do not stack multiple loads.
♦ Place the load centrally on the load area.
♦ Secure the load with the fastening bungee (see fig. 3).
♦ Make sure that the fastening bungee is sufficiently tightened so that the load
is firmly held in place.
♦ Also make sure that the fastening bungee is sufficiently tightened even for
small loads (see fig. 4). The arrow symbol
shows where the fastening
bungee can be hooked on.
♦ Move the product by pulling it behind you on both wheels.
1 2
To Next Page
Loading...
Need help?
General