- 27 -
• Mark the required points.
• Press once on the button
5
to switch the laser off.
Note:
Should you wish to project a horizontal line on the wall, tip the
appliance through 90 degrees. Align the Digital Laser Tape
Measure with the help of the water glasses
3
for horizontal lines.
Cleaning and Maintenance
To avoid eye damage:
First remove the batteries
7
before cleaning the appliance. This will
prevent the inadvertent switching on of the appliance during cleaning.
• Clean the appliance with a dry or lightly moistened cloth only.
To avoid potential damage to the upper surfaces, do not use any
abrasive cleaning agents or detergents.
• If contamination is visible at the laser exit opening
8
, carefully
remove it with a cotton stick.
Maintenance
• NEVER open any parts of the appliance. Arrange for the
appliance to be repaired by specialists only.
• The appliance is maintenance-free. No form of maintenance,
either on or in the appliance, is intended for execution by the user.
In the event of malfunction or apparent damage, make contact
with Customer Services.
To Next Page
