Powerfix Z29948 User Manual

10 GB
Safety Instructions / Getting started
area with plenty of clean water and consult a doctor
immediately.
J Remove light dirt from the battery and product con-
tacts with a dry, non-fluffing cloth before inserting the
batteries.
J Remove the batteries from the product if it is not in use
for any length of time.
J
Make sure that the polarity is correct when you insert
the batteries. This is indicated in the battery compart-
ment. The batteries can otherwise explode.
J Insert the batteries with care. The product can other-
wise be damaged.
J Please do not dispose of used batteries in your house-
hold waste but take them to a designated collection
depot for special waste.
Q
Getting started
Q
Inserting / changing the batteries
j Note: First remove the protective foil from the device.
j Open the battery compartment
5
on the back of the
appliance.
j Remove the used batteries if need be.
j Insert two new 1.5 V
batteries (AAA) into the bat-
tery compartment
5
.
Note: Ensure correct polarity. This is indicated in the
battery compartment
5
.
j Close the battery compartment
5
again.
Q
Using the Multifunction Detector
Tip! Test the device before initial use on a metal pipe
or power line whose position you know exactly.
j Slide the function switch
3
to “METAL” in order to
locate metal pipes etc.
j Slide the function switch
3
to “VOLTAGE” in order to
locate power lines etc.
j Hold the measuring head
1
directly on the desired
point of the wall.
j Press and hold down the PUSH key
4
.
j Move the device slowly over the wall surface.
Note: Ensure direct contact between the measuring
head
1
and the wall.

Powerfix Z29948 Specifications

General

Brand	Powerfix
Model	Z29948
Category	Metal Detector
Language	English