Loading on a Vehicle
1. Position the PowerMate
®
as shown in "A"
close to the tailgate or rear of the vehicle
allowing room for the wheels of the
PowerMate
®
to clear the vehicle when raising.
2. Push the "LOAD DOWN" button to raise the
wheels until they rest on the vehicle bed.
Lower the Hook Bar and engage the Hook
Attachment (when installed) on the vehicle
bed as shown in "B" and Detail "A1".
3. Push the "LOAD UP" button and raise the
toeplate/load to the vehicle floor as shown
in
"C".
4. Disengage the Hook Attachment by pulling the
PowerMate
®
away from the rear of the
vehicle. The PowerMate
®
can now be
positioned anywhere on the vehicle bed.
Unloading from a Vehicle
1. Lower the Hook Bar and connect to the Hook
Attachment in the vehicle bed by positioning
the PowerMate
®
as shown in "C" and Detail
"A1".
2. Push the "LOAD DOWN" button to lower the
PowerMate
®
toeplate and load to the ground
as shown in "B".
3. Disengage the Hook Bar from the Hook
Attachment and stand the PowerMate
®
upright.
4. Push the "LOAD UP" button to lower the
wheels to the ground, whereupon the
PowerMate
®
can be manoeuvred as required.
5. If desired, the retractable dolly can be
unclipped and used in connection with the
Hook Bar as shown in "D" to take the load and
assist handling for horizontal movement.
POWERMATE
OPERATION
PowerMate
Operation Manua
PN 010320 Rev.E
Eng. 05/ 08/ 14
3.03
To Next Page
Loading...
Need help?
General
