4/8
4、Press the corresponding key and key to change the parameter value or selection parameter number;
5、At last press
key to exit parameter setting mode,return to sewing work mode.
100 100~800 200 Minimum speed
101 200~5000 3500 Maximum speed
102 200~5000 3000 Constant-stitch sewing speed
105 100~500 250 Trimming speed
107 1~9 2 Stitch numbers for soft start
108 100~800 200 Soft start speed
110 200~2200 1800 Start back tacking speed
111 200~2200 1800 End back tacking speed
112 200~2200 1800 Bar tacking speed
113 1~70 24 Stitch balance for start back tacking No.1
114 1~70 20 Stitch balance for start back tacking No.1
115 1~70 24 Stitch balance for end back tacking No.3
116 1~70 20 Stitch balance for end back tacking No.4
117 1~100 90 Stitch balance for back tacking speed @(P107 - Tacking stitches A = 1)
118 1~100 30 Stitch balance for back tacking speed @(P107 = Tacking stitches A)
11B 0~4 0
Start and end back tacking type (CD and AB)
0：B->AB->ABAB->none 1：B->none 2：B->AB->none 3：AB->none 4：AB->ABAB->none
11C 0~9999 0 Tens digit for each segment of A/B/C/D
11D 0~9999 0 Tens digit for each segment of E/F/G/H
11E 0~9999 0 Tens digit for each segment of A/B/D
11F 0~359 0 Back tacking under angle control
130 0／1／2／3 2
Speed curve adjustments:
0：ramp curve 1：polygonal curve. 2：quadric curve 3：S-type curve
131 200~4000 3000 The turning point speed of two segment curve.
132 0~1024 800
The turning point sampling voltage of the pedal when two segment curve (Between
parameter 138 and 139)
133 1／2 1 The type of polygonal curve: 1: square 2：rooting
134 0~1024 90
Trimming point of pedal
135 0~1024 300
Footer lifting point of pedal
136 0~1024 460 Neutral point of pedal
137 0~1024 480 Motor running point of pedal in low speed.
138 0~1024 580 Accelerated point of pedal
139 0~1024 962 Max speed point of pedal
Figure 4-1 shows the specific setting
method
13A 0~800 100 The running delay time of footer lifting
140 0／1 1 Soft start at the first cycle of power ON. 0: disable 1: enable
141 0／1 1 Auto bar tacking function: 0: disable 1: enable
142 0／1 0
Bar tacking mode selection:
0：Juki mode. Active when motor stop or running. 1：Brother mode. Active only when
motor running.
To Next Page
Loading...