5
Safety Information
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
IMPORTANT: Store the power washer indoors in a
heated environment to prevent the water in the unit
from freezing and expanding. When the water freezes
and expands, the high-pressure pump will crack
and render the pressure washer inoperable. It is
recommended you use pump saver (not included) to
protect pumps from freezing and cracking.
• NEVER use hot water with your power washer. It will
overheat and damage the seals and components in the
high-pressure pump that cannot be repaired.
• NEVER leave the power washer “ON” while it is
unattended.
• ALWAYS turn the water supply “ON ” before turning
the power washer power to “ON”. Running the
pump dry of water will cause damage to the internal
components and render the pressure washer
inoperable.
• NEVER use a water supply to your power washer that
exceeds 150 PSI maximum.
• NEVER disconnect the high pressure hose from the
power washer while the system is pressurized.
• NEVER permanently engage the trigger mechanisms
on the spray gun.
• NEVER operate the power washer unless all
components are properly and securely connected.
• NEVER allow the power washer pump to run for
more than one minute after you have turned off the
water supply. This can cause the motor and pump to
overheat and fail.
• NEVER use an extension power cord since it causes
voltage drop and can burn the motor. Also increases
risk of electric shock to the operator
• NEVER use lances or other parts that are not
compatible for this specific Powerplay unit.
• NEVER spray any electrical outlet with your power
washer.
• Inspect the power cord before using. DO NOT use it if
it is damaged.
Preparation
Before beginning assembly of product, make sure all parts
are present. Compare parts with package contents list and
hardware contents list. If any part is missing or damaged,
contact customer service at 855-770-7529, DO NOT attempt
to assemble the product.
Estimated Assembly Time: 10 minutes
To Next Page
Loading...
