What to do if Powerplay PJR 2000PC Pressure Washer won't turn on?
First, ensure your Powerplay pressure washer is switched OFF. Plug the electrical cord directly into a grounded 120-volt outlet, avoiding any extension cords. If the plug doesn't fit, the outlet may not be properly grounded; try a different outlet. If it is still not working, call Customer Service.
What to do if my Powerplay PJR 2000PC turns on for 2 seconds, shuts off, and will not turn back on?
The water sensor in the pump detects moving water and automatically turns on the Powerplay pressure washer. When the water is connected, the accessories are properly assembled, and the power switch is on, the pressure washer may turn on briefly to prime the pump. It will then shut off and wait for the spray gun trigger to be pressed. Additionally, try turning the power switch off, holding the trigger on the spray gun to ensure a steady water stream, and then simultaneously turning the power switch back on while still holding the trigger.
Why is water leaking where the high pressure hose connects to the spray gun of my Powerplay PJR 2000PC?
Water leakage at the high-pressure hose connection to the spray gun on your Powerplay Pressure Washer is likely due to a missing o-ring. Ensure there is an o-ring at the end of the metal tip of the high-pressure hose.
How to connect the high pressure hose to the spray gun of Powerplay PJR 2000PC Pressure Washer?
The rubber sleeve covering the fitting at the end of the high pressure hose may be the reason for connection problems. Wiggle, twist, or pull the rubber sleeve down until the entire tip and an additional 1/8 inch of the metal fitting below the tip are visible. Then, try inserting the hose tip into the spray gun. Also, remember not to push the release button when connecting the high pressure hose.
What to do if my Powerplay PJR 2000PC Pressure Washer is running but there is no water flow?
If your Powerplay Pressure Washer runs but no water flows, first check the water source. Then, unclog the nozzle on the lance, referring to the nozzle cleaning instructions. Alternatively, remove the lance and spray directly from the spray gun to determine if the issue lies with the lance itself.
General| Brand | Powerplay |
|---|---|
| Model | PJR 2000PC |
| Category | Pressure Washer |
| Language | English |
To Next Page