17
ASSEMBLY INSTRUCTIONS
Step 2:
2a: Locate the tongue assembly and rotate the jack into the down position.
2b: Remove the hold down bolt that secures the tank to the base of the pallet.
2c: Position the tongue so that the mounting holes align with the holes in the tanks tongue mount.
2d: Insert the two M12 x 110mm bolts with a flat washer under the head of the bolt.
2e: Install a flat washer, lock washer, nut on each bolt and tighten.
1 32 4 5 6
Item Description Quantity
1 Tongue Assembly 1
2 Tank Assembly 1
3 M12 x 110 Bolt 2
4 Flat Washer 4
5 Lock Washer 2
6 M12 Nut 2
7 Ground Stand / Jack Stand 1
To Next Page
Loading...