Troubleshooting
ALWAYS CHECK INSTRUCTION MANUAL FOR PROPER ASSEMBLY OF PARTS
PROBLEM POSSIBLE CAUSE SOLUTION
Fastener Overdriving Power level too high / Pin too short Use a lower powder load level number or a longer pin
Soft base material Check base material suitability section
Tool does not fire Tool not depressed completely See "Tool does not depress completely" section below
Firing pin damaged Replace damaged part(s)
Tool does not depress completely Damaged firing pin parts, ejector, Check the parts for damage or improper assembly
etc. Parts assembled improperly
Power reduction or inconsistent Barrel is not pulled fully Barrel must be pulled out completely to properly
fastener penetration forward when cycling tool. reset the piston
Worn or damaged piston Replace piston or piston ring
or piston ring
Load strip cannot be Improper loading Insert strip from the bottom of the tool handle
inserted into tool
Wrong caliber strip Use proper strip
Load strip will not advance Worn advance lever guide Replace advance lever guide.
This should be performed by qualified individuals
Load will not fire when Tool is not fully depressed Follow safety procedure for misfired load then
trigger is pulled attempt to fully depress tool before pulling trigger
Load will not fire when Load is already fired Cycle tool
tool is fully depressed
and trigger is pulled
Load misfire Follow safety procedure
Broken firing pin Replace firing pin nut. This should be performed by
qualified individuals
Broken or missing Replace firing pin nut. This firing pin nut should be
performed by qualified individuals
12 P3500
MODEL P3500 CAT. NO.52000/Deluxe Kit 52001/Blister Pack
To Next Page
Loading...
