Introduction
Thank you for purchasing the Powers P3500 low velocity powder actuated tool. This tool will
provide you with excellent performance provided the steps for proper operation and
maintenance are followed. Powder actuated fastening systems can provide a cost effective
method of attaching fixtures for light duty, static load conditions. The systems provided by
Powers Fasteners consist of specially designed fasteners, installation tools, and powder loads
which are designed to function in combination to provide optimum performance. While powder
actuated tools can provide one of the fastest and economical means of fastening, they can also
be dangerous if they are not operated properly.
Prior to operating the P3500 tool, you must be properly trained in the operation and
maintenance of this tool and be issued a Powers Fasteners Qualified Operator Card. When using
the tool, you must have this card in your possession. As part of the training process, you should
read and understand the contents of this instruction manual especially the safety precautions.
Powder actuated tools may be operated only by properly trained operators as described in ANSI
Standard A 10.3, Safety Requirements for Powder Actuated Fastening Systems. For complete
tool operation details, contact your local Powers Fasteners Branch office or distributor
for training.
Remember, safety begins with you! It is your primary responsibility when operating this tool.
Failure to follow the proper operating, maintenance, and safety procedures can result in serious
injury or death to yourself or bystanders. In addition to the training provided, you should be
familiar with any local, state, and federal regulations. If you have any questions which are not
covered in this manual, contact your local Powers Fasteners Branch office or distributor.
SIZE RANGE
1/2" to 3" pin lengths, .27 caliber
TOOL DESCRIPTION
The P3500™ is a low velocity, semi-automatic .27 caliber tool which can be used to install .300
head drive pins, 8mm head drive pins and 1/4"-20 threaded studs, up to 3" in total length. The
P3500™ is designed for high speed and repetitive volume applications.
TECHNICAL DATA
TOOL BODY PIN LENGTH TOOL LENGTH
Precision Cast Aluminum 1/2" to 3" Total Length 13-5/8"
LOAD TYPE TOOL WEIGHT POWER LEVEL
.27 Caliber in a 10 Load Strip 5 lbs. Brown (2), Green (3), Yellow (4), Red (5)
PIN TYPE
Ballistic Point Drive Pin, .300 Head Drive Pin, 8mm Head Drive Pin, 1/4"-20 Threaded Stud
Warranty
All warranties of the products described herein, expressed or implied, including the warranties of
merchantability and fitness for particular purposes are specifically excluded, except for the
following: Powers Fasteners will repair or replace at its sole option any tool part, or fastener
which within five years after sale by Powers Fasteners or its distributors, is found by Powers
Fasteners to be defective in material or workmanship, normal wear and tear excluded.
This is the sole warranty of Powers Fasteners and the sole remedy available to distributor
or buyer.
NOTE — JUST AS NO ONE CAN MERELY READ A BOOK ABOUT DRIVING AN AUTOMOBILE AND THEN HOPE TO RUN IT SAFELY, NO ONE SHOULD
ATTEMPT TO USE ANY POWDER TOOL WITHOUT ADEQUATE, COMPETENT, PERSONAL INSTRUCTION. AND, JUST AS NO AUTOMOBILE
INSTRUCTION BOOK OR INSTRUCTOR CAN FOREWARN A LEARNER AGAINST ALL CONTINGENCIES AND EMERGENCIES, NEITHER CAN POWERS
FASTENERS INSTRUCTORS OR PRINTED INFORMATION DETAIL ALL POSSIBLE CONDITIONS SURROUNDING THE USE OF POWERS TOOLS AND
PRODUCTS. THE MANUFACTURER DISCLAIMS RESPONSIBILITY FOR INJURIES TO PERSONS OR PROPERTY WHICH MAY RESULT FROM DISREGARD
OF THESE OPERATING INSTRUCTIONS.
2 P3500
MODEL P3500 CAT. NO.52000/Deluxe Kit 52001/Blister Pack
To Next Page
Loading...
