ASSEMBLY AND ADJUSTMENTS
Unpacking
Unpack the Pole Saw and all its parts, and compare against the list below. Do not discard the carton or
any packaging until the Pole Saw is completely assembled.
Install the pole saw
1. Loosen the adjusting knob near to the handle and slide the inner and outer tube.
2. Loosen the adjusting knob near motor head and insert the inner tube of motor head until heard “click”
sound. Then tighten the adjusting knob.
3. Pull inner tube out to desired length of extension then tighten the adjust knob near the handle.
Chain Lubricating Oil
Use high quality chain lubricating oil to minimize wear between the saw chain and guide bar while in use.
We recommend using SAE No. 30 in the summer and SAE No. 10 in the winter or when cutting resinous
wood. Check the oil level prior to each use.
WARNING - The chain saw is not supplied filled with oil. It is essential to fill with oil before
use. Never operate the chain saw without chain oil or at an empty oil tank level, as this will
result in extensive damage to the product.
To Next Page
Loading...