TROUBLESHOOTING
The following form lists the common operating system with problem and solutions. Please read the form
carefully and follow it.
PROBLEMS POSSIBLE CAUSES SOLUTION
not run.
· The battery pack is not
attached to the chain saw.
· There is no electrical contact
between the saw and battery.
· The battery pack is depleted.
· The battery pack or chain
saw is too hot.
· The back-off button is not
depressed before pressing the
trigger switch.
· Chain brake is engaged.
· Saw chain is bound in the
wood.
· Debris in bar groove.
· Debris inside cover.
· Attach the battery pack to the chainsaw.
· Remove the battery, check contacts and reinstall
the battery pack.
· Charge the battery pack.
· Allow the battery pack or chainsaw to cool.
· Press down the lock-
off button and hold it, then
depress the trigger switch to turn on the chain
saw.
· Pull the chain kickback brake handle backward
toward the front handle.
· Release the trigger switch; remove the saw
chain and guide bar from the wood, then restart
the chain saw.
· Press the saw chain against the wood, move the
chain saw back and forth to discharge the debris.
· Remove battery pack, then remove side cover
and clean out debris.
n does not
· Chain does not engage drive
sprocket.
· Reinstall the chain, making sure that the drive
links on
the chain are fully seated on the sprocket.
not engage.
· Debris preventing full
movement of the chain
kickback brake handle.
· Clean debris from extremal chain brake
mechanism.
To Next Page
Loading...