Powersmart PS76821SRB User Manual (English)

Questions and Answers:

M
mauricetaylorAug 6, 2025
Why my Powersmart PS76821SRB Lawn Mower does not start?
- A
  Adam RiveraAug 7, 2025
  Your Powersmart Lawn Mower might not start due to several reasons. The battery may not be charged, so charge the battery. The switch could be defective, requiring a replacement. There might be grass jammed at the blade; in this case, remove the battery and check under the deck for jams. Also, verify the connection between the motor connector and the battery. The battery may require service or replacement, so call customer service at 1-800-791-9458 or replace the battery. Finally, make sure the upper handle is properly installed.
Z
zacharyjohnsonAug 12, 2025
How to fix uneven grass cutting with Powersmart PS76821SRB?
- A
  Alan LaneAug 12, 2025
  If your Powersmart Lawn Mower cuts unevenly, it could be due to a rough or uneven lawn; therefore, check the mowing area. Another reason might be that the cutting height is not set properly. Adjust the wheels to a higher setting to resolve this.
C
Carla GuerraAug 18, 2025
What to do if Powersmart PS76821SRB is excessively noisy and vibrates?
- J
  Jody RoachAug 18, 2025
  If your Powersmart Lawn Mower is excessively noisy and vibrates, stop the motor and inspect for damage, as the motor shaft might be bent. Also, the blade could be unbalanced; repair it before restarting. If the vibration persists after these steps, call customer service at 1-800-791-9458.
M
Margaret DavidAug 25, 2025
How to improve mulching with Powersmart PS76821SRB Lawn Mower?
- D
  Dawn PooleAug 26, 2025
  If your Powersmart Lawn Mower isn't mulching properly, wet grass clippings might be sticking to the underside of the deck. Wait until the grass dries before mowing. Alternatively, the side discharge might be missing; install it to resolve the issue.
D
David AlvarezAug 30, 2025
Why is my Powersmart PS76821SRB hard to push?
- J
  Jeffery CollinsAug 31, 2025
  Your Powersmart Lawn Mower might be hard to push because the grass is too tall, or the cutting height is too low. Raise the cutting height. Another reason could be that the rear of the mower housing and the blade are dragging in thick grass. Empty the grass clippings from the grass catcher bag to alleviate this.