Need help?Do you have a question about the PowerTec 3000C and is the answer not in the manual?
Explains the function of terminals on Current Controller, Speed Controller, and Current Sensor boards.
Covers safe lifting practices and critical safety warnings regarding high voltages.
Guidelines for mounting chassis in enclosures, ensuring proper airflow and support.
Details mounting orientation, ambient temperature limits, and required free air space.
Emphasizes importance of installation for operational life and preventing electrical noise.
Specifies power source requirements, KVA rating, fuse capacity, and voltage tolerance.
Details methods for connecting the motor to the control, including leads and ground.
Control uses analog speed reference input via voltage. Standard speed control uses +10VDC reference.
Control responds to external frequency signal at TB1 terminals 11 and 9 for speed control.
Maximum output current allowed when powering the load. Set by horsepower calibration resistor.
Follow sequence of events and consult diagrams. Use LED indicators for diagnostics.
Verify LED status during run, check current limit, and test feedback operation.
To Next Page
General