EasyManua.ls Logo

PowerTec PL1252 - Default Chapter; Table of Contents

PowerTec PL1252
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TABLE OF CONTENTS
PRODUCT
SPECIFICATIONS
MOTOR
SPECIFICATIONS
Horsepower (Maxmum Developed).............................. 2 HP
Voltage..........................................................................120 V
Amperes..........................................................................15 A
Hertz..............................................................................60 Hz
Phase............................................................................Single
Motor RPM.........................................................17,500 RPM
Table Size...................................................12-1/2”×9-5/16”
Blade Width...............................................................12mm
Maximum Depth of Cut................................................3/32”
Cuts per Minute........................................................18,800
Planer is supplied with a 2 HP motor installed.
The 120 Volt AC universal motor has the following
specifications:
Horsepower (Maximum Developed) . . . . . . . . . . . . . 2 HP
Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .120
Amperes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
Hertz. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
Phase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Single
Cutterhead RPM . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9,400
SAFETY RULES 1
Work Preparation
Work Area Preparation
Tool Maintenance
Tool Operation
ASSEMBLY 2
Unpacking
Install Dust Chute
Install Elevation Crank Handle
Power Source
Grounding Instructions
Extension Cords
Electrical Connections
OPERATION 5
Safety Precautions
Rollercase Height Adjustment
Depth of Cut
ON/OFF Switch
Circuit Breaker
Before Operating the Planer
Operate the Planer
MAINTENANCE 8
Check and Replace the Blades
Inspect and Replace the Motor Brushes
Adjust Rollercase Level
Replace V-Belt
Clean and Lubrication
TROUBLESHOOTING 10
PARTS ILLUSTRATION & 12
LIST
WARRANTY 14
SECTION PAGE

Related product manuals