CHANGING ENGINE OIL
1. Stop the engine.
2.
Let engine sit and cool for several minutes (allow
crankcase pressure to equalize).
3.
Remove the engine service panel to gain access to
the oil fill/drain plug.
4.
Place oil pan (or suitable container) under the oil fill/
drain plug (see Figure 13).
Figure 13: pan under plug
5.
With a damp rag, thoroughly clean around the oil
fill/drain plug.
6.
Tilt the
so the oil drains down the through
into the container.
14: so oil into pan
7. Allow oil to completely drain.
8. Fill crankcase with oil following the steps outlined in
Adding
.
9. Dispose of used engine oil properly.
NOTICE
Never dispose of used engine oil by dumping the
oil into a sewer, on the ground, or into groundwater
or waterways. Always be environmentally
responsible. Follow the guidelines of the
or
other governmental agencies for proper disposal
of hazardous materials. Consult local authorities or
reclamation facility.
AIR FILTER MAINTENANCE
Never use gasoline or other flammable
solvents to clean the air filter. Use only
household detergent soap to clean the
air filter.
Cleaning the Air Filter
The air filter must be cleaned after every 50 hours of
use or 3 months (frequency should be increased if
is operated in a dusty environment).
1.
the and let it cool for several
minutes if running.
2.
Remove the engine service panel to gain access to
the air filter.
3.
Unscrew the air cleaner cover and tip the cover
down (see Figure 15)
4.
Remove the foam element from the air cleaner
housing.
Figure 15: Unscrew cleaner cover
22.
www.powertec.net.nz
PT3200i
3000W DIGITAL
INVERTER GENERATOR
To Next Page
Loading...
