2
ASSEMBLY
ASSEMBLY
2
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether
all parts and accessories are included.
ITEM DESCRIPTION QTY
A Ultra-work stand 1
B Extension bars 2
C Roller bars 2
D Locking knobs 4
E Handle 1
F Screws and lock nuts (handle) 2
G Power tool mounting hardware
(mounting bolt, washer, lock washers and
nut)
4
H Pan head screws 2
B
A
F
C
D
E
G
Figure 1
H
WARNING
Do not use the ultra-work stand until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool
being used with this ultra-work stand.
WARNING
Do not use the ultra-work stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 330 lbs. (150 kg). Power tools
on the ultra-work stand should not exceed a combined
overall height of 60" (152.4 cm) from the floor.
TOOLS NEEDED
The following tools (not included) are needed to assemble
the ultra-work stand:
Phillips head screwdriver
10 mm open end wrench
UNFOLD THE WORK LEGS
Refer to Figure 2
• Place the ultra-work stand on a flat surface with the
folded legs facing up.
• Depress the leg release spring pins and rotate the leg
until it clicks and locks into the open position. Repeat for
each leg.
Figure 2
Leg
Leg Release
Spring Pins
• Place the ultra-work stand in the upright position on a
flat surface.
ASSEMBLE HANDLE
Refer to Figure 3
• Secure handle to frame with hardware supplied.
Figure 3
Lock Nut
Handle
Screw
To Next Page
Loading...