PowerTec UT1004 - Assemble Extension Bar;Roller Bar Locking Knobs; Mounting the Power Tool

3
ASSEMBLY
ASSEMBLY
3
ASSEMBLE EXTENSION BAR/ROLLER BAR
LOCKING KNOBS
Refer to Figure 4, 5
The two extension bars can be assembled in the
extension bar brackets found at the right and left of the
stand.
Figure 4
Extension
Bar Bracket
Extension
Bar Bracket
Extension
Bar
Locking Knob
Pan Head Screw
• Slide the extension bar into the extension bar bracket.
Insert the pan head screw into the hole in the end of
extention bar.
• Slide the extension bar in or out to desired location and
secure in place with locking knob.
• Place the roller arm into the roller bar support, slide up
and down to desired location and secure in place with
large locking knobs.
Figure 5
Roller Bar Support
Locking Knob
Roller Bar
MOUNTING THE POWER TOOL
WARNING
Risk of accidental starting and serious personal injury.
Unplug the power tool before attaching it to the ultra-work
stand.
WARNING
Risk of serious personal injury. Always make sure the
power tool is fully supported and securely attached to
a level work surface. Make sure the ultra-work stand is
located on a flat surface.
IMPORTANT: Use the mounting hardware supplied to
mount the power tool to the ultra-work stand. Always
insert the bolt from the bottom of the ultra-work stand.
Secure at all four feet of the power tool.
• Place the tool to be used on the table top.
• Move the tool around until the hole pattern matches
the slot combination on the table top, secure with the
mounting hardware supplied.
• Insert the bolt through the bottom of the table and
secure with flat washer, lock washer and nut.
Figure 6
Bolt
Lock Washer
Nut
Flat Washer