Now it is time to put the top section of the gym on. The cable is stuffed up the inside of the top section. Just reach in and pull it
out like above. Ideally you should have two people for this part of the assembly, but if you don’t here is how you do it.
Put the top part on your shoulder and feed the cable through the top of the base. Then you will be able to pull it out the cable
outlet at the bottom. Be careful when doing this. Don’t drag the cable hard through the chassis – you will shred it.
It is very important that the cable is pulled all the way through the bottom outlet before attempting to put the top of the frame
on. If there is a lot of slack at this point you may catch the cable – once again just take your time and it is easy. The top frame
will just slide in now.
To Next Page
Loading...
