PowerTec WB-LTO16 - Attaching Part No 8 (Step 7); Attaching Part No 5 (Step 8)

Step 7. Attach part No 8 to the part No 7.
Attach the pads to the part No 8 and put the caps on the end of the tube. Then place No 8 in to part
No 7 and put the bolt, washer and nut (35, 38, 41). After placing the bolt put the pin No 27 into
place.
Step 8. Attach part no 5 to the Power rack using nuts and bolts (No 36, 38, 41) and a plate (No 9)
which goes to the back of the rack.
No 7
No 8
No 38,35 41
No 27