■
■■■
The decimal point then flashes. If you want to adjust this, press The "UP" or "TOTAL:' button. If the
point stays that way, press the "SET" button to confirm the setting.
To set price 2, you need "Price 2" instead of "Price 1" at the beginning select and set. Make sure
that there are no time overlaps both rates are. The time settings should not be identical!
Example: For a kWh price of 0.24 $ / kwh you have to enter 0.24. If you only want to set a tariff, set
the period to all 7 days of the week and the beginning at 0.00 o'clock.
CO2 Settings: After you have set the prices and confirmed them, you will get into the CO2 settings
(CO2 equivalent). At best, you can get that value from your Get energy suppliers know.
The display will show "SET CO2'~ Use the "UP" and "TOTAL:' buttons to set the Unit of measurement
(kg/ kWh or lb/ kWh). Then press the "SET" button, to confirm the setting.
Subsequently, the first digit of the CO2 setting flashes. Put these with the Press "UP" and "TOTAL:'
and repeat this procedure with the second one and third place. Confirm the setting with the "SET"
button.
Then press the "SET" button again to return to the normal display to return.
DISPLAY & MODES
In the normal display mode, you can use the "MODE" key between the following:
Change modes in the first line: Display of the costs since the beginning of the measurement;
Power display; Voltage display, current consumption of the load and CO2 mode.
The second line shows the accumulated data for costs, consumption or CO2 emissions. This data
can be accessed by pressing the "TOTAL:' key between weekly, monthly and yearly totals.
RESET THE DEVICE
Press the "RESET" button on the front of the unit with a pointed tip Item to clear all settings and
restart the device.
Attention! Make sure you do not hurt yourself with the item!
To reset only the accumulated data, press and hold the Buttons "TOTAL:' and "UP" simultaneously
for 2 seconds. Following are the accumulated data reset to zero.
To Next Page
Loading...