What to do if AC power fails and my Powertronix PTX 2 M UPS is in battery mode?
If the AC utility power fails while the Powertronix UPS is in battery mode, reduce the load to extend backup time. If it is not a power failure, check the rated input or connected power line.
General| Apparent Power | 2000 VA |
|---|---|
| Active Power | 1600 W |
| Input Voltage | 230 V |
| Output Voltage | 230 V |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Waveform | Sine Wave |
Critical safety warnings covering electrical hazards, battery handling, installation environment, and usage.
Essential guidelines for UPS placement, ventilation, and electrical wiring.
Instructions for starting, shutting down, and performing battery start-ups of the UPS.
Guide to adjusting the UPS output voltage and frequency settings through the LCD.
Procedure for setting the low (LO) and high (HI) voltage limits for bypass mode.
Detailed procedures for battery replacement, testing, and safety precautions.
Lists common issues indicated by LCD messages and audible alarms, with solutions.
Interpretation of LED patterns and associated troubleshooting actions for UPS faults.
A detailed reference table correlating LED displays with operating statuses and alarms.
To Next Page
