PPA Agility Hibrida - Brake, Light, and Reset Functions; Brake Function Configuration; Courtesy Light Time Setting; Factory Settings Restoration

30
BRAKE
It is activated when the motor is turned off by a command, or when the opener rea-
ches the analog sensors (limit switches).
In󰍰ructions:
1. The gate mu󰍰 be 󰍰ill;
2. Close the ‘JPROG’ jumper;
3. Press and release the ‘BRAKE’ button on the board (once) to show the current
adju󰍰ment;
4. Press and release the ‘BRAKE’ button as many times as necessary until one rea-
ches the desired adju󰍰ment;
5. In order to finish, open the ‘JPROG’ jumper.
LED indications:
• • ‘N1’ flashing = Function disabled
• • ‘N1’ lit = Minimum.
...
• • ‘N8’ lit = Maximum.
COURTESY LIGHT TIME
It selects the time in which the ‘LIGHT’ output will remain activated after the gate
closes.
During the opening or closing maneuver, or when the gate is 󰍰ill and open, the relay
module will remain enabled. Whenever the control board finishes the closing maneu-
ver, the relay module will be disabled after the time set.
In󰍰ructions:
1. The gate mu󰍰 be 󰍰ill;
2. Close the ‘JPROG’ jumper;
3. Press and release the ‘LIGHT’ button on the board (once) to show the current
adju󰍰ment;
4. Press and release the ‘LIGHT’ button as many times as necessary until one reaches
the desired adju󰍰ment;
5. In order to finish, open the ‘JPROG’ jumper.
LED indications:
• ‘N1’ flashing = Immediate shutdown.
• ‘N1’ lit = 5 seconds.
• ‘N2’ lit = 10 seconds.
• ‘N3’ lit = 30 seconds.
• ‘N4’ lit = 60 seconds.
• ‘N5’ lit = 90 seconds.
• ‘N6’ lit = 120 seconds.
• ‘N7’ lit = 180 seconds.
• ‘N8’ lit = 240 seconds.
ERASING THE ACQUIRED PATH AND RESTORING THE DEFAULT FACTORY
SETTINGS
In a single operation, it erases the path (travel) of the gate acquired (memorized) by
the control unit as well as it re󰍰ores the default factory settings.
In󰍰ructions:
1. The gate mu󰍰 be 󰍰ill.
2. Keep the ‘JPROG’ jumper open.
3. Press the ‘SET’ button on the control unit and keep it pressed; the ‘SN’ LED will
remain off.