User Manual
ScanLog 96 Pen Drive Version
9
Select Operation
If the “Pen Drive Checking” operation is successful; the ScanLog presents one or more of the following options for the next
operation:
None
Copy (New)
Re-copy (Old)
Read Set.txt File
Recover
The above option list is presented one option at a time. Use UP / DOWN keys to view the options & then press ENTER key to
select the option. Select option ‘None’ to revert to normal RUN mode screen.
The ‘Copy (New)’ option is presented only if there are new records available in the internal memory and the ‘Recover’ option is
not presented.
The ‘Re-copy (Old)’ option is presented only if there are old records available in the internal memory and the ‘Recover’ option
is not presented.
The ‘Read Set.txt File’ option is presented only if the inserted Pen Drive contains a file with the name Set.txt.
The option ‘Recover’ is presented only if the previous write file operation was interrupted. In this case, the ‘Copy (New)’ and
‘Re-copy (Old)’ options are not presented.
Use UP/DOWN keys to select the desired option and then press ENTER key to execute the selected operation.
Pen Drive Checking
Upon inserting the Pen Drive into the USB port, the ScanLog responds by displaying the
message shown in the figure 3.3(a). During this time, the ScanLog checks the file format on the
Pen Drive and also searches for existence of Set.txt file (file containing Instrument Name, File
Name & Channel Names) and any interrupted file-write operation in the previous operation. The
message may last for 5 to 60 seconds depending upon the disc size and occupancy percentage.
In case of any error in reading the Pen Drive or if the Pen Drive dose not respond for more then
60 seconds, the message shown in the figure 3.3(b) is displayed.
Ensure proper insertion of the Pen Drive into the USB port and acknowledge the message by
pressing front panel ENTER key. The ScanLog repeats the device checking operation. If the
error persists; remove the Pen Drive from the port and acknowledge the message (using
ENTER key). The ScanLog responds with the message shown in the figure 3.3(c). Acknowledge
the message to revert to normal RUN mode screen or insert a new Pen Drive to continue with file
read/write operations.
PEN DRIVE (MEMORY-STICK) OPERATION
The ScanLog is provided with a front panel USB port for file read and write operations using Pen Drive.
Figure 3.3(a)
Please Wait.....
Figure 3.3(b)
Device Failure
Figure 3.3(c)
Insert Drive
To Next Page
Loading...