25
must be repaired.
c) Disconnect the plug from the power source and/or remove the
battery pack, if detachable from the power tool before making any
adjustments, changing accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting the power tool
accidentally.
d) Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to
operate the power tool. Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools and accessories. Check for misalignment or
binding of moving parts,breakage of parts and any other condition
that may affect the power tool’s operation. If damaged, have the
power tool repaired before use. Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and
the work to be performed. Use of the power tool for operations different
from those intended could result in a hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and
grease. Slippery handles and grasping surfaces do not allow for safe
handling and control of the tool in unexpected situations.
5) Service
a) Have your power tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the safety of the
power tool is maintained.
3
、
SAFETY INSTRUCTIONS FOR SAW
Cutting procedures
a )
DANDER :
Keep hands away from cutting area and the blade. Keep
your second hand on auxiliary handle, or motor housing. If both hands are
holding the saw, they cannot be cut the blade.
b ) Do not reach underneath the workpiece. The guard cannot protect you
from the blade below the workpiece.
c ) Adjust the cutting depth to the thickness of the workpiece. Less than
a full tooth of the blade teeth should be visible below the workpiece.
d ) Never hold the workpiece in your hands or across your leg while
cutting. Secure the workpoece to a stable platform. It is important to
To Next Page
Loading...